How to Remove the Back Panel From a Refrigerator
- Pull the refrigerator away from the wall.
- Unplug the power cord from the power outlet.
- Locate the screws that hold the back panel in place.
- Remove the screws with a flathead or crosshead screwdriver.
- Grab the end corners of the panel with your fingertips.
Considering this, do you take the cardboard off the back of the fridge?
Refrigerators come with a cardboard or metal cover on the rear of the refrigerator, at the bottom. This should not be removed, as it protects components at the bottom of the refrigerator.
Beside above, is it safe to dismantle a fridge? Yes, you can. But it will take equipment that you probably don’t have. Generally, the hardware, baffling/ductwork, and electricals will come out with simple hand tools: screwdriver, wire snips, that sort of thing. The refrigerant system is where you’ll likely have problems.
Similarly, how do you remove the back of a Whirlpool refrigerator?
How to Remove a Whirlpool Refrigerator Freezer Back Panel
- Pull the refrigerator away from the wall and unplug the power cord from the wall outlet.
- Open the freezer door and remove all of the contents of the freezer.
- Remove the shelves of the freezer by lifting the front of the shelf and then pulling the shelf out of the freezer.
How do you remove the back panel of a Kenmore freezer?
Removing the freezer panel is really not very difficult. First, disconnect the power and then remove everything in the freezer. Now you can remove the air tower and screws holding the back panel in place and pull the panel forward.
8 Related Question Answers Found
How do you remove the grill from a Whirlpool refrigerator?
How to Remove the Base Grill on a Whirlpool Refrigerator Locate the base grille at the bottom of the front of your refrigerator below the freezer door or drawer. Grasp the grill on both sides using your hands and then pull it toward you. Grab the grill from underneath if you have a hard time detaching it, and then pull up the bottom to fully remove the grille.
Where is the drain pan on a Whirlpool refrigerator?
Drain pan WPW10614158 is at the bottom of the cabinet behind the toe grille and collects water that runs out the drain line during defrost. Replaces original refrigerator drain pan part numbers 1105523 and W10614158.
How do you disassemble a refrigerator for scrap?
An average sealed unit can weigh around 30lbs. from a fridge. If you want to scrap a sealed unit for the copper inside it can be difficult to break open the steel casing, but we suggest scrapping it as a whole unit. You should have clipped the copper tubing around the sealed unit and the back of the fridge.
How do you remove the front panel of a Whirlpool refrigerator?
How to Remove the Dispenser Front on a Whirlpool Refrigerator Locate the slot on the bottom of the plastic trim, located on either the left or right side. Insert the flat-head screwdriver or butter knife into the slot. Pry the corner of the plastic trim off of the front of the refrigerator, being careful not to break the plastic trim.
How much scrap is in a refrigerator?
How Much Is A Fridge Worth In Scrap? The average fridge weight is 150 lbs. At . 10 a pound, that puts the value of a scrap fridge at $15 for scrap metal.
What is inside a refrigerator compressor?
1. The compressor constricts the refrigerant vapor, raising its pressure, and pushes it into the coils on the outside of the refrigerator. Now in liquid form at high pressure, the refrigerant cools down as it flows into the coils inside the freezer and the fridge.
How can I recycle my refrigerator for cash?
How to Get Cash for Your Old Refrigerator Sell it on Craigslist. Sell it in a Yard Sale. Sell the Scrap Metal in It. Call an Appliance Recycling Center. Call Local Power Companies. A Note about Appliance Stores. Sears. Lowe’s.
How do you turn off a refrigerator?
Shut down your refrigerator properly. Remove all food from the refrigerator. Set the refrigerator’s temperature control to the “Off” position. Turn off the ice maker in the freezer by lifting the swing arm to the upper locked position. Shut off the water supply valve, which is a spigot located on the wall.