But if your refinished bathtub has a texture that feels rough, pointy, or like sandpaper (and you didn’t have a non-slip surface applied) this could indicate that the surface wasn’t sanded or cleaned properly before the coating was applied. It could also be that dust and debris got trapped in the finish.
Besides, can you refinish a tub that has already been refinished?
Yes, you can reglaze (in other words re-surface or refinished) a bathtub that has been reglazed before. If the surface has noticeable wear even when the bathtub hasn’t frequently been used, it could be that the original refinish job was not done currently or did not dry completely soon after the service.
Moreover, is Reglazing a tub toxic?
The epoxy coatings used to finish bathtubs can also emit dangerous vapors such as isocyanates when sprayed. These are classified as potential human carcinogens according to the U.S. Department of Labor, and protective gear should be worn when working with them.
What is the difference between refinishing and reglazing a bathtub?
So the main difference between the “bathtub refinishing” and “bathtub reglazing” is that the former refers to the entire restoration project and the latter refers to the commercial coating applied at the end of the process.
What is used to refinish bathtubs?
Refinishing a bathtub is a less costly alternative to full replacement of the fixture; however, the process often involves the use of hazardous chemicals including methylene chloride, acids and isocyanates. What is methylene chloride?
Why does the bottom of my bathtub feel like sandpaper?
Cause – Anytime the pH rises too high, even if it is for a short period of time, the calcium in the water will precipitate out and start forming on the surface of the spa. It will start out as a white powder and then turns into hard crystals that feel like sandpaper on the surface.
Why is the bottom of my bathtub rough?
Rough Texture: If the surface of the tub wasn’t cleaned or sanded properly, it could result in a rough texture. Sticky to the Touch: If the tub feels sticky or tacky to the touch, it means the coating didn’t cure properly. … If your client drops something hard onto the newly reglazed bathtub, it can chip the surface.