In a pool plumbing system, there are pipes that bring water from the pool (suction pipes), and one or more pipes that take water back to the pool (return pipes). Pool valves are used to control the direction of water flow, to and from the pool, and in and out of equipment.
Beside this, what is a pool skimmer valve?
The float valve in the bottom is designed to shut off the skimmer and keep it from sucking air into the pump if the water level in the pool gets too low. On some systems where the skimmer and drain are both plumbed into the skimmer, the float valve serves to regulate the flow of water from the skimmer and the drain.
Also, should skimmer valve be open or closed? A normal pool valve setting would have the skimmer valve(s) fully open, main drain half-open and spa drain fully closed. To operate a suction pool cleaner or manually vacuum the pool, you can close other skimmers, or close the main drain, to obtain more suction through the skimmer you are using.
which valve is main drain in pool?
The Main Drain – draws water from the bottom of the pool into the filter system. They each have an individual pipe that converges into one pipe just before your pump and filter. Typically, there is a valve that allows you to adjust the water flow from these two pipes.
Does my pool need a check valve?
Raised Pool Pumps The most common use for a check valve is to hold the water in the pump when the motor shuts off. When doing so however, you will need to install check valves on all vertical suction pipes, unless one pipe normally has a closed valve, like a spa drain pipe.
7 Related Question Answers Found
Should pool skimmers be on all the time?
Although it’s generally recommended that all the pool water undergo filtration every 24 hours, the pump does not need to run all the time. A proactive, productive and energy-saving maintenance activity is to remove the debris floating on the pool surface with a hand-held skimmer.
How do you open a valve?
The proper way to open a gate valve is to gently turn the handle counter-clockwise (to the left) without applying excessive force – do not ‘jerk’ the handle. A typical 1″ main control valve for a water line will take about six full turns to fully open. Stop turning as soon as there is any resistance.
How does a pool 3 way valve work?
In effect a 3-way valve operates as a Tee fitting, with adjustable flow rates to or from each pipe attached to the valve. A simple pool may have one 3-way valve installed in front of the pump, to control the flow from the skimmer and main drain. This results in 25% flow from the drain, and 75% flow from the skimmer.
Should pool main drain be open or closed?
Opening the main drain and then closing the cleaner valve. So it is either main drain+skimmer or cleaner+skimmer. Never main drain+skimmer+cleaner all open at the same time. All valves open will not hurt the equipment, but the cleaner will not operate correctly.
How do pool valves work?
Pool valves are used to control the direction of water flow, to and from the pool, and in and out of equipment. In between our suction pipes and the return pipe are the pool pump and filter, and maybe a heater. It allows for consolidation of two leaky, hard to turn gate valves into one simple operation.
What causes air in pool lines?
If you are seeing a significant number of bubbles coming out of your return lines into the pool, you probably have an air leak in your filtration system. Possible sources of this problem are low pool water levels, leaks around the strainer lid, leaks in the unions or leaks in the pump seals.
What does a Jandy valve do?
The two port Jandy valve controls the flow of water through a pipe, much like a traditional gate valve or ball valve would operate. This valve has an internal diverter. In the graphic, the off “block” is to the side, allowing the water to pass freely through the valve.