How tight should a snowblower belt be?

When It’s engaged, it should be fairly tight. It may or may not have an adjustment to tighten the belt when needed. One thing to look at is if your belt is old, it may have worn the sides of it enough to actually drop the belt farther into the pulley which could cause slipping under snow loads.

Correspondingly, how long do snowblower belts last?

about five to seven years

Additionally, why does my snowblower belt keep breaking? Check the pulleys for wear or bent places on a pulley. Check the bearings in the pulleys, if a bearing is seizing, it will throw the belt off or break it. An impact, bounce, or shifts to the pulleys, caused by uneven distribution of loads will hyperextend the belts maximum strength design.

Considering this, why does my snowblower not throw snow far?

A clogged chute won’t throw snow very far. If the chute isn’t clogged, check the augers and auger drive system. A damaged auger blade can’t push snow through the shoot, and broken shear pins keep sections of the auger from spinning.

Why does my snowblower dies when Auger engaged?

I suspect there is something jamming the auger or the impeller. If you cannot turn the impeller check for ice built up around the impeller. If you find it is frozen up, you can free it with warm water. As soon as the impeller is free, start the engine and run the auger to clear it out.

3 Related Question Answers Found

How many belts does a snowblower have?

For most two stage snow blowers, there are 2 or 3 belts under the cover. One belt will drive the auger, and the other will drive the wheels.

How fast does a snowblower auger spin?

3600 rpm motor, 1 to 2 belt reduction to the fan (impeller?), and a 10 to 1 reduction to the screw (?? that big auger thingie that brings the snow into the center to be blown out over the bank.) This gives an impeller rotation speed of about 1700 rpm, and a screw rotation of 170 rpm or about 3 revolutions per second.

How do you adjust the idler pulley?

Turn the adjustment bolt on the side, top or bottom of the pulley counterclockwise with the ratchet and socket until the accessory belt is loose enough to remove. Tighten the tensioner pulley by turning the adjustment bolt clockwise with the ratchet and socket until the belt is tight.

Leave a Comment