Press and hold the “PROGRAM” button on top of the (HPU) hydraulic pump unit for 3 seconds until the LED turns solid green (HPU will also beep). 2. Press and hold either the UP or DOWN button on the wireless controller you are pairing until the unit responds.
Moreover, what fluid goes in a power pole?
Power-Pole has developed Green Marine hydraulic fluid to provide the performance of a petroleum product without the harmful effects. This ISO-32 fluid is ideal for use in Power-Pole systems, trim tabs, jack plates, tilt and trim rams, hatch lifters and more.
Subsequently, question is, how do I reset my power pole remote?
- Featuring.
- Press and hold the PROGRAM button on the top of the unit for 3 seconds until the LED turns green (HPU will also beep).
- To raise or lower the spike, press and hold either the UP or DOWN button on the remote control.
- Ensure the surrounding area is as dry as possible to avoid any moisture intrusion.
- Figure 1.
Furthermore, how do I change the battery in my power pole remote?
STEP 1: Remove Key Fob Cover using a Flat-Tip screwdriver. FIG 1 STEP 2: Remove Switch Membrane and Circuit Board from the base FIG 2 STEP 3: Remove battery from holder and replace with a CR2032 3v Lithium Coin Battery. STEP 4: Reassemble Key Fob. Make sure Switch Membrane is seated properly.
What weight is ISO 46 hydraulic oil?
Traveller Hydraulic Oil ISO 46 (SAE 20 Equivalent) is a high quality hydraulic oil that is specifically formulated to protect against rust, corrosion, foaming, oxidation and meets or exceeds the requirements for industrial and mobile hydraulic systems.
4 Related Question Answers Found
How do you program a power pole dash switch?
1. Press and hold the PROGRAM button on the top of the unit for 3 seconds until the LED turns green (HPU will also beep). The unit is now ready to be paired with the wireless dash switch. NOTE: I f dual units are installed, repeat Steps 1-3 to pair multiple units to a single wireless dash switch.
How do you program a power pole foot switch?
Make sure Switch Membrane is seated properly. STEP 1: Press and hold the PROGRAM button on top of the unit for 3 seconds (LED will turn GREEN/HPU will beep). STEP 2: Press the UP or DOWN button on controller for one second. When Paired, the GREEN LED will turn off then flash steadily (HPU will also beep).
How do you raise a power pole manually?
STANDARD MODE To raise or lower the Power-Pole, press and hold either the UP or DOWN button on the key fob. The anchor will only continue to move so long as you press the button.
Where is the serial number on a power pole?
Your serial number is located on the stern bracket. This is the bracket that mounts either directly to the boat or adapter plate. The serial number will be located underneath the stern bracket or on the side. Does Power-Pole offer custom colors?