Popular General Electric Dishwasher Valves. This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoid on the valve open and close according to the desired amount of water needed.
Hereof, where is the water inlet valve on a dishwasher?
Locate your dishwasher’s water inlet valve. It should be located behind the lower kickplate panel in either the right or left corner. There will likely be two screws either on the top of the panel, or on its bottom.
Furthermore, why won’t my GE dishwasher fill with water? If the water inlet valve is clogged with sediments, the dishwasher won’t fill properly. Inspect the valve to determine if is clogged. In addition, check the water pressure to the valve. The water inlet valve requires at least 20 psi to function properly.
Similarly, it is asked, why is no water coming into my dishwasher?
Your dishwasher may not be filling with water simply because the water valve’s filter screens are dirty and debris-filled. Gain access to your water inlet valve and try cleaning it out. Alternatively, your water inlet valve could be defective altogether. That could be the reason your dishwasher is not filling.
Can you clean a dishwasher inlet valve?
The inlet valve on the dishwasher connects to the dishwasher control panel. To access the valve screen and clean any debris that might be clogging your inlet valve, you must remove the inlet valve from the dishwasher. If the inlet valve is defective, you must replace it.
4 Related Question Answers Found
Why is my GE Profile dishwasher leaking?
Over time, age and detergents can dry out the rubber gasket that seals the pump to the bottom of the tub, causing a leak. Loose hose clamps and hoses: Hose clamps secure the drain hose and the circulating hose to the dishwasher pump. If they’ve come loose or the hoses have cracked, that could be the cause of the leak.
What does a dishwasher water inlet valve do?
The dishwasher water inlet valve controls the flow of water into the dishwasher. If no water flows into the dishwasher, or if the water won’t stop flowing into the dishwasher, replace the water inlet valve with a manufacturer-approved replacement part.
Where is the water inlet valve?
Start this repair by locating your washer’s water inlet valve. It will be at the back of the washer, and it will have water hoses hooked up to the back of it. Shut off the supply of water to your washer.
What is a water inlet valve?
The water inlet valve on your washing machine is the part that the connect the two water hoses to the machine, and it controls the flow of both hot and cold water. Replacing a bad valve is a simple job and must be done with parts and procedures that are specific to your washing machine model.